18 Using the system
User’s manual
Chapter 4
USING THE SYSTEM
This chapter describes all the operations users can carry out with or without
authorization (user PIN entry). The tools and methods which allow access the
system operations are as follows.
The system can be accessed:
•Via Keypad nCode/S
The keypad allows users to operate the system:
1. by means of shortcuts (refer to paragraph 3-1 Keypad shortcuts);
2. by means of access codes via the User Menu (refer to paragraph 2-5
User Codes and paragraph 3-2 Shortcut with code). This chapter
describes the procedure via menu as described at paragraph 2-5-1
Accessing the User Menu.
•From Reader (nBy/X and nBy/S)
This proximity-key reader provides users with only one way of accessing
the system, as described in paragraph 3-3 Keys and readers shortcuts.
•Via Command Zone
After violation of a duly-programmed zone which sends a command to
the control panel.
•via Wireless keyfob
by means of keys to as described in paragraph 2-6-1 Air2-KF100
Wireless keyfobs.
To Next Page
Loading...
Need help?
General