22 Using the system
User’s manual
The “Panel version” section allows you to view the firmware version and
model of your Ability control panel.
When viewing the wireless zones, the last line on the display indicates the
level of signal strength on a scale of 0 to 7; the higher the value the better
the signal.
Via Keypad
Method 1
Activate the shortcuts associated with keys to
(shown on the
display) with or without code entry.
• The shortcut assigned to “View menu” (shortcut n.12), allows you to
access the respective section in the User Menu and view the contents of
the:
•• Events log
•• Alarms log
•• Faults log
•• Arm/Disarm ops.
User access to the information in the “Logs” is filtered. For example, a
user can view only the zone alarms relating to the partitions the code
and keypad concerned have in common. Press keys
and to
scroll the chronological events list. For some events, key allows you
to view the partitions details. For example, the details of an “Arm”
command will show the code and keypad concerned and, if you press
, the list of partitions involved.
•• System voltage
•• Zone status - allows you to view only the zones associated with the
partitions the code and keypad concerned have in common. Use keys
and to scroll the list of zones.
•• Faults
•• PanelVersion
• Other shortcuts which provide direct access to sub-sections of the
“View” section are:
•• Shortcut n.21 accesses “View/Events log”
•• Shortcut n.22 accesses “View/Alarms log”
•• Shortcut n.23 accesses “View/Faults log”
•• Shortcut n.24 accesses “View/Arm/Disarm ops.”
•• Shortcut n.25 accesses “View/System voltage”
•• Shortcut n.26 accesses “View/Zone status”
•• Shortcut n.29 accesses “View/Faults”
Method 2
Access the "View" section of the User menu by means of a valid PIN.
Follow the instructions described in Method 1.
PanelVersion
2.00 1030B ABIL
To Next Page
Loading...
Need help?
General