To Next Page

To Previous Page

Wallbox eMH1 – Taking the Wallbox eMH1 out of operation |

English

Taking the Wallbox eMH1 out of operation

In case of severe malfunctions or damage to the device, you must take the Wallbox eMH1 out of opera-

tion. To do so, proceed as follows:

Wallboxes eMH1 with integrated RCCB only:

1 Open the housing cover of the wallbox using

the key supplied and flip it up.

2 Flip the pivot lever of the internal RCCB to

the 0 position.

3 Close and lock the housing cover of the

wallbox.

All Wallboxes eMH1:

4 Open your domestic power distribution box

and disconnect the power supply cable from

the electricity grid.

y Wallboxes without integrated RCCB:

In addition, flip the pivot lever of the

RCCB to the0 position.

y Close the domestic power distribution

box.

The Wallbox eMH1 is no longer connected to the electricity grid and can be removed by a qualified spe-

cialist electrical contractor if required.

Danger

Dangerous electrical currents

Always measure the voltage between the phases and the neutral conductor of the power supply cable

before you start dismantling the wallbox.

Other manuals for ABL WALLBOX eMH1

Questions and Answers:

Need help?

Do you have a question about the ABL WALLBOX eMH1 and is the answer not in the manual?

General