Timer
Default time is 10 minutes. Press the UP/DOWN button once to
increase or decrease the time increment. Maximum time is 45 minutes.
11. To switch the unit off, press and hold the ON/OFF button for three
seconds.
12. To turn the sound on/off, press and hold the FUNCTION and
ON/OFF button for 2 seconds. The display will show the ‘sound
off’ icon
Auto Functions
If the conductive area of the belt (the grey area on the back of the belt)
does not touch the skin, the intensity can only be set up to “1”. An
alarm will sound after 2 seconds and the unit will automatically switch
off. If the belt is removed during use, the intensity is automatically reset
to “1”. If the belt is not immediately placed back into contact with the
skin, the unit will automatically turn off after 20 seconds. The
AbTronicX2 unit has an auto-timer. It will automatically switch off after
10 minutes of exercise. If you change the exercise mode during the 10
minute exercise period, the timer will continue to count-down from the
original leftover time.
What to do if you do not feel any muscle contraction
If no muscle contractions are felt, move the belt slowly around the area
that you want to target. Make sure you have enough AbTronicX2
slimming gel placed on the inside of the neoprene belt. Gradually
increase the PULSE INTENSITY by pushing the UP button for each
channel in the mode until muscle contraction is felt.
The AbTronicX2 dual channel belt is a great way to exercise your
muscles. It may take a few moments of practice to locate the belt
correctly and apply the ideal pressure that will produce the best results
for you.
Tip! If there is not enough gel on the belt or the belt is not placed
tightly against the skin, you may experience an uncomfortable tingling
sensation. The same thing will happen if the conductive pads are worn
and have lost good conductivity.
13
To Next Page
Loading...