ABTronic 2X - Fitting the AbTronicX2 Belt

How to Fit your AbTconicX2 belt:
a. The AbTronicX2 belt has been pre-adjusted to fit a stomach girth of
35’’-38’’ (89-97cm). The control unit is attached to the belt.
b. Please look at the rear Velcro flaps how to adjust the belt and
check how to attach the control unit.
c. Detach the control unit and insert the batteries.
d.
WITHOUT GEL: Adjust the belt to fit tight, but comfortable around
your stomach. The front and rear should be positioned in the centre
of your stomach and back.
Adjust the size of the belt, by folding the belt into the rear Velcro
flaps approximately symmetrically on both sides if necessary
Belt size adjustment, Small(S)/Medium (M)/Large (L)
You can adjust the belt
size in S/M/L. According
to the size indicators and
the folding line, you can
fold the belt into the rear
Velcro flaps approximately
symmetrically on both
sides for S/M/L size
adjustment.
M
S
L
Foldin
g
Line
8
For Large size approx. 39-44''
For Medium size approx. 32-36''
For Small size approx. 24-29''
L
M
S
e. If your stomach girth is larger than 45’’ – 46’’ please attach the
Velcro belt between the open ends of the belt as an extension.
f. After achieving a good fit take the belt off.
g. Fit the 4 conductive pads targeting the desired exercise areas.