ABTronic 2X - Adverse Effects

ADVERSE EFFECTS
Skin irritation and burns beneath the electrodes has been reported with
the use of electrical muscle stimulation.
Trouble Shooting Guide
PROBLEM POSSIBLE CAUSE SOLUTION
LCD Display
does not light
up at all
- Batteries not
installed
- Batteries installed
incorrectly
- Batteries are empty
- Install Batteries
- Check polarity “+” sign
- Replace Batteries
LCD Display
lights up, but
warning beep
is emitted
(high pitch
warning tone
beeps)
- No skin contact
- Unit not snapped on
belt correctly
- Microprocessor hang
up
- Battery is low
- Use water based gel on
conductive pads and
place belt directly onto skin.
- Check that unit is
connected firmly with
all connectors to the
belt.
- Check that all
conductive pads are
connected firmly
to the belt.
- Choose mode and
Increase intensity by
pushing the up buttons
for
left and right channels
- Perform a RESET,
removeBatteries for 1
minute for full RESET
- Change Battery
LCD Display
lights up, but
nothing
occurs
- Intensity set to low
level
- Not enough
conductive
gel on belt
- Choose mode and
Increase intensity by
pushing the up buttons
for left and right channels
- Put more water based gel
between belt and skin
- Read label on the gel
35