Abus IPCB24500 - System; General; Firmware;Reset; Log File

89
10.4.5 System
10.4.5.1 General
Camera name: you can change the default camera name here. Up to a
maximum of 31 characters are permitted.
Permissible characters are: A-Z, a-z, 0-9
Export configuration: export the camera' s configuration data into a file
Import configuration: import the camera' s configuration data from a file
Reset settings: restore all settings to factory settings, except network
settings
Include network: after ticking the checkbox and performing the function for
resetting settings, all settings including the network
parameter are reset.
10.4.5.2 Firmware/Reset
Current firmware: displays the firmware version currently installed
Firmware online check: this function checks whether a new firmware version is
available on the ABUS website. If there is, the camera offers
to download the firmware on to the PC (download link). Then
the firmware must be manually installed using the firmware
update function.
Firmware update: a more recent version of the camera firmware can be
installed here. More information on firmware is available
on the ABUS website (www.abus.com).
Restart: manual camera restart
Schedule restart: the camera can be restarted here at a specific frequency.
10.4.5.3 Log file
Log file: data relevant to the system is recorded in the log file. This can help with
troubleshooting, for example.
Export: exporting the log file into another file
10.4.6 Motion detection
List of ranges: displays all the ranges of movement set
Display all: tick the checkbox to display a preview of all ranges at the same
time.
Range name: name of range
Ignore the threshold value: The threshold value is ignored, thereby causing any small pixel
change movement. This setting can be advantageous with a wide
image width (e.g., outside). However, a delay before alarm should
be used.
Delay before alarm: Delay time before a motion alarm is triggered after recognition of the
image change.
Add: after assigning the range a name and pressing this button, a new
entry is created in the list. Then click on the list entry to select a