Abus TVIP62500 - Description of the Status Leds; Description of the Reset Button Function

49
3.5 Description of the status LEDs
State Description
Off IP address allocation
On IP address allocation successful
Flashes max. 3 times Communication with IR LED circuit
board/photo sensor established
3.6 Description of the reset button function
Restoring the factory settings
a) Remove the power supply unit from the camera.
b) Press the reset button.
c) Reattach the power supply unit whilst holding down the reset button, then keep it held down
for 10 seconds.
Restarting
a) The camera is restarted if the reset button is pressed once briefly.