50
3.7 Putting into operation
You can use the supplied patch cable for direct connection when putting into operation for the first time.
Direct connection of the network camera to a PC/laptop
1. Ensure that a CAT 5 network cable is used.
2. Connect the cable to the Ethernet interface of the PC/laptop and the network camera.
3. Connect the power supply to the network camera.
4. Configure the network interface of your PC/laptop to the IP address 192.168.0.2 and
the default gateway to 192.168.0.1 / subnet mask 255.255.255.0.
5. Go to point 3.8 to finish the initial set-up and establish the connection to the network camera.
Connecting the network camera to a router/switch
1. Ensure that a CAT 5 network cable is used.
2. Connect the PC/laptop to the router/switch.
3. Connect the network camera to the router/switch.
4. Connect the power supply to the network camera.
5. If a DHCP server is available in your network, set the network interface of your PC/laptop to
“Obtain an IP address automatically”.
6. If no DHCP server is available, configure the network interface of your PC/laptop to 192.168.0.2
and the default gateway to 192.168.0.1 / subnet mask 255.255.255.0.
7. Go to point 3.8 to finish the initial set-up and establish the connection to the network camera.
CAT 5 Ethernet cable
Internet
To Next Page
Loading...
