Camera
Settings
Trigger Channel tab
Select one or more camera channel(s) to react in the
event of an alarm.
Confirm the settings by clicking on Apply and exit the
menu by clicking on OK.
Arming Time Schedule tab
Here you set the times at which the reactions set in the
Linkage Action tab are triggered.
1. Select the day and enter the time schedule.
Note
Up to eight time slots, between 00:00 and 00:00,
can be defined in each case, but the individual
time slots must not overlap.
2. Under Copy, select whether or not the setting should
be applied to every day of the week and the holiday
settings.
Note
To record with the aid of motion detection, you
must set up the time schedule under Record.
Note
The sensitivity settings for motion detection need
to be adjusted on the camera web interface.
3. Confirm the settings by clicking on Apply and exit
the menu by clicking on OK.
Linkage Action tab
Here you can configure the response of the recorder in
the event of an alarm by ticking the corresponding box.
Parameter Notifications
Full Screen Monitoring
The camera is displayed in
full screen in live view.
Audible Warning
The device does not have an
audible warning.
Notify Surveillance Cen-
tre
The CMS sends out a warn-
ing message
Send Email An email is sent to a specified
email address. See page31
Trigger Alarm Output
The alarm output is triggered
in the event of an alarm.
• Confirm the settings by clicking on Apply and exit
the menu by clicking on OK.
40
To Next Page
Loading...
