Accu-Chek ACTIVE Getting Started Guide

1. Starting to use the Accu-Chek Mobile system
Getting Started Guide - Accu-Chek
®
Mobile
www.accu-chek.com.au
Accu-Chek Enquiry Line: 1800 251 816
Mobile
Accu-Chek
®
Mobile
Open the tip cover
A
completely as far
as it will go. Only then will you be able
to open the cassette compartment and
insert the test cassette.
Push the slide button
B
upwards. This
opens the cassette compartment cover.
Remove a new test cassette
C
from
the packaging. Insert the test cassette
into the meter. Close the cassette com-
partment cover and the tip cover.
Pull the protective strip of the battery
D
backwards out of the meter to activate
the batteries. Remove the protective
film from the display.
Press the button
E
for about
2 seconds until the meter turns on.
Use the buttons to select the
language
F
.
Press the button to set the
desired language
G
.
Press the button to confirm the
selected language
H
.
kim_manual_0090
A
kim_manual_0280
C
kim_manual_0180
E
kim_manual_0240
B
D
1.
5.
2. 3. 4.
6.
F
7.
G
8.
H
W
If you have set the wrong language by mistake, you may not be able to read the menus any more. You can nevertheless change the language. The instructions can be found in Chapter 5.2 of the
User’s Manual under the section Correcting a wrongly set language.
4 5

Accu-Chek ACTIVE Specifications

General

Measurement Range	10-600 mg/dL
Sample Size	1 - 2 μL
Test Time	5 seconds
Memory Capacity	500 results
Display Type	LCD
Automatic Coding	Yes
Blood Sample	Capillary whole blood
Dimensions	97.8 x 46.8 x 19.1 mm
Battery Type	1 x 3V lithium battery (type CR2032)
Battery Life	Approximately 1000 tests
Data Transfer	Via infrared (IR) to computer
Operating Conditions	8-42°C, 10-85% RH