Accu-Chek ACTIVE Getting Started Guide

Exchange drum
Turn dial to select depth setting.
For beginners, select a lower setting.
(Start with level 1.)
You’re ready to test:
Press, click, and twist.
D
C
Set penetration depth
Getting Started Guide - Accu-Chek
®
Multiclix
A
Remove cap.
C
When number 1 appears in the display,
last lancet is in use.
A
Remove cap.
B
Insert new drum with blue ring end first.
Snap drum into place. Replace cap.
D
Remove used drum. (It cannot be reinserted.)
Dispose of drum with household waste.
B
Load new drum.
Load drum
A B
For more information,
please visit www.accu-chek.com.au
Getting Started Guide - Accu-Chek
®
Multiclix
2
Press lancing device rmly against side
of fingertip and press release button.
Step 2 Click
Step 3A Twist
Step 1A Press
1B
3B
1A
Press priming button down like a
ballpoint pen.
3A
To change lancet, turn priming button
as far as it will go, and turn back again.
1B
The transparent release button turns
yellow.
3B
The numbers on the display show how
many lancets are left.
3 simple steps to teach and learn
26 27

Accu-Chek ACTIVE Specifications

General

Measurement Range	10-600 mg/dL
Sample Size	1 - 2 μL
Test Time	5 seconds
Memory Capacity	500 results
Display Type	LCD
Automatic Coding	Yes
Blood Sample	Capillary whole blood
Dimensions	97.8 x 46.8 x 19.1 mm
Battery Type	1 x 3V lithium battery (type CR2032)
Battery Life	Approximately 1000 tests
Data Transfer	Via infrared (IR) to computer
Operating Conditions	8-42°C, 10-85% RH