85
Other Information
84
Transferring Data
The meter turns on without
advancing a test strip from
the test drum and displays
two arrows.
Two arrows flash on the display
while the meter automatically
downloads all stored blood sugar
results to your computer. If there
is only a small amount of data,
the arrows may not flash on
the display.
The download is complete within
just a few seconds and the meter
turns off automatically.
A message is displayed on the
computer indicating that the data
transfer is complete. Refer to the
software user’s manual for the
specific message displayed.
• If the data transmission did not occur or was
incomplete, the meter turns off automatically
after five minutes.
• To make the most of the download feature, you
must set the year, date, and time in your meter.
7. With the meter turned
OFF, press the SET and
MEM buttons at the
same time and release.
To Next Page
Loading...
Need help?
General
