Accuphase C-280 - Low LEVEL INPUTS

PARTS AND THEIR FUNCTIONS (rear panel side)
17
13 14 15
[13] Low LEVEL INPUTS
For DISC 1/DISC 2, two sets of phono
jacks are provided so that two turn-
tables or one turntable with two
tonearms can be connected to the
C-280. Shorting pin plugs are
inserted in the DISC 2 jacks before
shipment. They should be left in
place when only the DISC 1 jacks are
used.
If both sets of DISC jacks are used,
gently pull out the shorting pin
plugs and insert them in two of the
LINE input jacks. The shorting pin
plugs can be inserted in any pair of
input jacks, but they should never be
inserted in the output (TAPE REC,
OUTPUTS) jacks. If this is done, по
sound will be heard and a malfunction
may result. Remember to connect the
turntable ground terminal to one of
the rear panel GND jacks before
playing a record for the first time.
All three GND jacks are the same so
it does not matter which one you use.
HIGH LEVEL INPUTS
TUNER / LINE 1/LINE 2
Connect the tuner output cables to
the TUNER jacks. The LINE 1 and LINE
2 jacks can be used for a COMPACT
DISC player, second tuner, third tape
fis}
19
16 18
deck or any other suitable audio or
video component.
TAPE 1/ TAPE 2
PLAY / REC
Two sets of playback and recording
jacks are provided so that two tape
decks can be connected at one time.
The tape deck LINE OUT cables should
be connected to the PLAY jacks and
the LINE IN cables to the REC jacks.
To make a recording, the tape record-
ing switch [8] must be in the ON
setting. The signal output from the
TAPE REC jacks is not affected by the
settings of the volume control, atte-
nuator or compensator. The recording
level should be set on the tape deck.
OUTPUTS
These consist of two pairs of phono
jacks and one pair of XLR type con-
nector jacks. The output impedance of
the phono jack outputs is 1 ohm,
unbalanced. The output impedance of
the XLR type outputs is 600 ohms,
balanced, to permit easy connection
with professional components.
Refer to the connection diagram for
details.