Accutron FlowTrax IS - 3.2 Programming Datasheet

8 | Page
3.2 Programming Datasheet
Before programming the Accutron IS, it is a good idea to record the parameters in the following form.
The form should also be filed for future reference.
Menu Option
Default Setting
New Setting Entered
Configuration Menu
(1A)
Flow units
A (M/S)
(1B)
Linear units
A (Meters)
(1C)
Face to face distance
0.0
(1D)
Baseline distance
0.0
(1E)
Cross section area
0.0
(1F)
Air flow direction
A (Normal sign)
(1G)
Zero flow cut-off
0.0
(1H)
Instrument full scale
1000.0
(1I)
4-20mA over range
A (Saturate/Clipping)
(IJ)
Obstruction/fault
timeout in minutes
100 (disabled)
(1k)
4-20mA mode
A (0V 0% 2V 100%)
(1L)
Moving average
15
Advanced Menu
(2A)
Calibration Correction
1.0
*(2B)
Noise filter
0
*(2C)
Wave detection low
threshold
20
*(2D)
Wave detection high
threshold
70
*(2E)
Dynamic range limiting
factor
10
*(2F)
Hysteresis length
10
(2G)
XDUC Gain
D (4)
(2H)
Moving average type
B (First reading)
*(2I)
Alternate updates
B (Enabled)
*(2J)
Envelope Mask
0
Modbus Menu
(3A)
Address
1
(3B)
Baud Rate
B (19200)
(3C)
Parity
A (None)
(3D)
Stop Bits
A (1)
Note: Indicates parameters that should be left at default.