System Board 1-17
The SRAM must have an access speed of 15
nanoseconds.
Make sure that you set the jumpers properly.
See section 1.4.
1.10 Post-installation Instructions
Always observe the following:
1. See to it that the components are installed according to the step-
by-step instructions in their respective sections.
2. Make sure you have set all the required jumpers before you
proceed. See section 1.4 for the correct jumper settings.
3. Replace any expansion boards or peripherals that you removed
earlier.
4. Replace the system cover.
5. Connect the necessary cables and turn on the system.
To Next Page
Loading...
