1-20 User’s Guide
Set the Suspend Mode timer to a value from 2 to 120 minutes, or
activate the Suspend/Resume button. In Suspend mode, the turbo
LED light on the front panel blinks at a rate slower than when the
system is in the Standby mode. Activating the Suspend/Resume
button produces two beeps as the system enters the suspend mode.
Any keyboard/mouse or I/O action resumes full power.
Power-Management Modes
Table 1-7 Power-Management Modes
Monitor
Power-
Saving Mode
IDE Fixed
Disk Standby
Mode
System
Standby
Mode
System
Suspend
Mode
Monitor Mode
Suspend No effect Off On
IDE HDD
Status
No effect Standby
mode
Spindle
motor off
Standby
mode
Spindle
motor off
Standby
mode
Spindle
motor off
CPU/System
Status
Normal Normal Normal CPU clock
stopped
Entry Mode
Device idle
timer time-out
(1 - 15 min)
Device idle
timer time-out
(1 - 15 min)
System
standby timer
time-out
(2 - 120 min)
System
Suspend
timer time-out
(2 - 120 min)
or Suspend
button
pushed
Resume Mode
Device
activated
Any fixed disk
access
Any system
event
Keyboard/
mouse or
Resume
button
pushed
Resume
Recovery
Time
3 - 5 sec 3 - 5 sec 7 - 10 sec 7 - 10 sec
Application Condition
You must disable the Suspend mode for LAN workstations. Since the
CPU is stopped in Suspend mode, this prevents the workstation from
responding to LAN requests. Thus, the system is considered
disconnected from the network.
To Next Page
Loading...
