System Utilities 2-10
Set User Password [Enter]
This field shows always the default value
[Enter].
If the Supervisor Password is not set then the
User Password is grayed out.
1. Use the ↑ and ↓ keys to highlight the Set
Supervisor Password parameter and
press Enter. The Set Supervisor
Password dialog box appears
If you already have set a Supervisor
Password previously, the following dialog
box appears:
2. Type the current password in the Enter
Current Password field and press Enter.
3. Type the new password in the Enter New
Password field and press Enter.
4. Retype the new password in the Confirm
New Password field.
5. Press Enter. If the passwords match, the
Setup Notice dialog box appears.
If the current password entered does not
match the actual current password, press
Enter and re-type the passwords.
If the new password and confirm new
password do not match, press Enter and re-
type the passwords.
Product Information Example Remark
To Next Page
Loading...
