20
13. Carefully pry loose and remove the LED board from the upper case.
WARNING:The LED board is glued to the upper case, only remove the LED board if it is defective.
Removing the LCD Module
1. See “Removing the Battery Pack” on page 5.
2. See “Removing the Lower Cover” on page 6.
3. See “Removing the Lower Cover” on page 6.
4. See “Removing the Optical Drive Module” on page 7.
5. See “Removing the DIMM” on page 7.
6. See “Removing the Hard Disk Drive Module” on page 8.
7. See “Removing the SSD Module” on page 9.
8. See “Removing the RTC Battery” on page 9.
9. See “Removing the Keyboard” on page 12.
10. See “Removing the WLAN Board Module” on page 13.
11. See “Separating the Upper Case from the Lower Case” on page 14.
12. Release the wireless antenna cables from the latches.
To Next Page
Loading...
