Acer Aspire 4810 Series - Removing the Card Reader Board

27
12. See “Removing the System Board” on page 22.
13. Release the daughter board from the latch.
14. Carefully lift the daughter board and remove it from the lower case.
Note: Circuit board > 10cm
2
has been highlighted with the red rectangle as shown in the figure
above. Please detach the circuit board and follow the local regulations for disposal.
Removing the Card Reader Board
1. See “Removing the Battery Pack” on page 5.
2. See “Removing the Lower Cover” on page 6.
3. See “Removing the Lower Cover” on page 6.
4. See “Removing the Optical Drive Module” on page 7.
5. See “Removing the DIMM” on page 7.
6. See “Removing the Hard Disk Drive Module” on page 8.
7. See “Removing the SSD Module” on page 9.
8. See “Removing the RTC Battery” on page 9.
9. See “Removing the Keyboard” on page 12.
10. See “Removing the WLAN Board Module” on page 13.
11. See “Separating the Upper Case from the Lower Case” on page 14.
12. See “Removing the System Board” on page 22.