Acer Aspire M1100 - Password Management

Chapter 2 49
Set Supervisor Password
When this function is selected, the following message appears at the center of the screen to assist you in creating
a password.
Enter Password
Type the password, up to eight characters, and press ENTER. The password entered here overwrites any
previously entered password from CMOS memory. You will be asked to confirm the password. Type the password
again and press ENTER. You can press ESC to abort the selection.
To disable password, just press ENTER when you are prompted to enter password. A message will confirm the
password being disabled. Once the password is disabled, the system will boot and you can enter BIOS Setup
freely.
Supervisor Password has higher priority than User Password. You can use Supervisor Password when booting the
system or entering BIOS Setup to modify all settings. Also you can use User Password when booting the system
or entering BIOS Setup but can not modify any setting if Supervisor Password is enabled.
X
Frequency/Voltage Control
X
Integrated Peripherals Set User Password
Phoenix - Award WorkstationBIOS CMOS Setup Utility
X
Product Information
X
PC Health Status
X
Standard CMOS Features
X
Advanced BIOS Features Load Optimized Defaults
X
Advanced Chipset Features Set Supervisor Password
X
Power Management Setup Save & Exit Setup
X
PnP/PCI Configuration Exit Without Saving
F10: Save & Exit Setup
Change/Set/Disable Password
V02.54 (C) Copyright 1985-2004, American Megatrends, Inc.
Esc: Quit
KLIJ
: Select Item
Enter Password: