Chapter 3 61
Reassembly Procedure
1. Insert the system power supply in to the chassis and secure the four screws marked below.
IMPORTANT:FSP and LITEON power supply cabling differ due to size constraints. For FSP power supplies,
use a power cable clip to secure the 12V cable. For LITEON power supplies, use a non-cable clip to
secure the 12V cable.
2. Insert the main board and secure the 8 screws marked below.
Note: Ensure that the I/O Connector is aligned and that the VIA aperture is correctly oriented with the STAND
OFF on the chassis.
FSP Power Supply LITEON Power Supply
To Next Page
Loading...
