54 Chapter 3
Angora AM50/30/10 Procedures
Use the following guides to disassemble and reassemble the AM50, AM30, and AM10 models.
Note: The only differences between the models are the front bezel and placement of the USB panel as shown
below. Take care when replacing the front bezel to avoid damage to the ports.
Disassembly Procedure
1. Place the system unit on a flat, steady and nonskid surface.
2. Release the lock handle then slide the left cover out.
3. Detach the VGA, TV, and Modem cards.
AM50 AM30
AM10
To Next Page
Loading...
