46 Aspire Z1650 AIO Computer Service Guide
4. Detach the heat sink.
Removing the Memory Modules
1. Remove the LCD assembly by following the procedure described on page 31.
2. Open the holding clips securing the memory module (1), then detach the memory module from the DIMM1
slot (2).
Note: A circuit board that is > 10cm
2
has been highlighted with a yellow rectangle as above image
shows. Please detach the circuit board and follow local regulations for disposal.
3. Repeat step 2 to remove the second memory module in the DIMM2 slot.
To Next Page
Loading...
