5-4 Jumper and Connector Locations
Jumper Setting 0
The section explains how to set jumper for correct configuration of the main board.
Setting Jumper 0
Use the mother board jumpers to set system configuration options. Jumpers with more Than
one pin are numbered. When setting the jumpers, ensure that the jumper caps are Placed on
the correct pins.
The illustrations show a 2-pin jumper.When the jumper cap is placed on both pins, the jumper
is SHORT.If you remove the jumper cap, or place the jumper cap on just one pin, the jumper
is OPEN.
Table 1-1.
No Label Description No Label Description
1 CPU socket
FM1 CPU socket
2DIMM
DDR Ⅲ DIMM slot
3 PCIE x16 PCIE x16 slot 4 Camera Camera module
connector
5 LCD LCD connector 6 converter converter connector
7 3D scalar
(reserved)
3D scalar connector
8 Key Pad Key Pad connector
9 CPU fan CPU fan connector 10 SATA PWR SATA Power
connector
11 Front Panel Front Panel
connector
12 Bluetooth Bluetooth connector
13 Touch Panel Touch Panel
connector
14 IR IR connector
15 Speaker Speaker connector 16 BIOS_WP BIOS_WP connector
17 Clear CMOS Clear CMOS
connector
18 SATA0-2 SATA connector
19 Battery RTC battery 20 SPI SPI header
21 LPC LPC header
To Next Page
Loading...
