System Utilities 2-23
AMI UEFI BIOS Flash SOP for SHELL 0
1.Please make a SHELL bootable device.
2.Copy BIOS folder into SHELL bootable device.
3.Boot to SHELL mode.
4.Type flash command as below: afushell64.efi Filename.rom /p /b /n /r
5.Please make sure the SHELL tool version is same as release note requirement.
6.After finishing flashing BIOS, please don’t execute any programs and reboot the system
directly.
7.When system reboot, please press “Del” to enter BIOS Setup.
8.In Exit page, select “Load Default Settings” and press “Enter” key.
To Next Page
Loading...
