How to fix Acer Projector image with vertical flickering bar?
Use 'Frequency' to make an adjustment. Also, check and reconfigure the display mode of your graphics card to make it compatible with the projector.
Why does Acer H7532BD lamp burn out or make popping sound?
When the lamp reaches the end of its useful life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in the 'Replacing the Lamp' section.
How to fix partial or incorrectly displayed image on Acer H7532BD (for PC)?
Press 'RESYNC' on the remote control or control panel. For an incorrectly displayed image: Open 'My Computer,' then the 'Control Panel,' and double-click the 'Display' icon. Select the 'Settings' tab. Verify that your display resolution setting is lower than or equal to WUXGA-RB (1920 x 1200). Click the 'Advanced Properties' button. If the problem persists, change the monitor display you are using and follow these steps: Verify the resolution setting is lower than or equal to WUXGA-RB (1920 x 1200). Click the 'Change' button under the 'Monitor' tab. Click 'Show all devices'. Next, select 'Standard monitor types' under the SP box, and choose the resolution mode you need under the 'Models' box. Verify that the resolution setting of the monitor display is lower than or equal to WUXGA-RB (1920...
Guidance on operating the projector safely using electrical power.
Information on when to refer servicing to qualified personnel.
Important safety guidelines for projector operation and placement.
Guide to connecting various devices to the projector using different cables.
Step-by-step instructions for powering on the projector and source devices.
Finding optimal image sizes based on projector-to-screen distance.
Adjusting projector position and zoom for desired image size.
Using the OSD for projector installation, maintenance, and settings adjustment.
Guide to navigating and using the projector's OSD for image adjustments.
Adjusting display mode, wall color, brightness, contrast, saturation, and tint.
Settings for projection mode, location, aspect ratio, keystone, and sharpness.
Configuring closed caption, auto screen, reset, and security settings.
Guide to solving common image and projector operational problems.
Step-by-step instructions for safely replacing the projector lamp.
To Next Page
General
