Acer KA270H - Page 8

ACER KA270H
8
S3
Disassemble the lamp wire
Tear down AL-Tape off SHD(Shielding) as picture 1.
Tear off the tape on the lamp wire and etract the lamp wire form the P/BD(Power Board)
as picture 2.
PICTURE 1 PICTURE 2
S4
Disassemble LVDS cable
and CTRL BD
Tear off the tape, pull out the FFC as picture 1.
Pull the CTRL BD-FFC out of the PCBA and the CTRL BD, tear off the tape and
disassemble the CTRL BD-FFC
PICTURE 1 PICTURE 2
S5
Disassemble the Bezel from
panel.
Tear off the tapes, take out the Panel and the CTRL BD of the Bezel
S6
Disassemble I/F BD and
P/BD from SHD.
Disassembled the Mylar and unlock all screws.
Disassemble the I/F BD from the SHD and extract the P/BD wire.
Extract the FFC LVDS from the I/F BD.
Disassemble the P/BD from the SHD.
PICTURE 1 PICTURE 2
NOTE: Circuit boards >10 cm² has been highlighted with the yellow rectangle as above image shows.
Please detach the Circuit boards and follow local regulations for disposal.
I/F BD
P/BD