Chapter 3 22
No Procedure Photo
1 Unscrew 6 screws in the
Bottom Cover, then, unplug 1
IR Receiver wire and 1 FPC
connector to remove Top
Cover Module.
2 Remove Keypad Board:
(1) Unscrew 4 screw and
unplug 1 FPC to remove the
Keypad Board.
(2) Separate all the keypad
components.
3 IR Receiver:
Tear off the mylar to remove
the IR Receiver directly.
2. Remove and disassemble Top Cover Module
To Next Page
Loading...
