Acer PREDATOR G7710 SERIES - Installing an Expansion Card; PCI Bus Slots Interface

6 Upgrading your computer62
English
Installing an expansion card
This section explains how to install an expansion card and a second CrossFire-
Ready graphic card.
PCI bus slots interface
3 PCI Express x16 slots compatible with PCIE 2.0 specification, supports CrossFire
mode.
• The mazarine PCIE x16 (PCI_EX1, 3, 5) slot supports PCIE x16 speed
• The blue PCIE x16 (PCI_EX2, 4) slot supports PCIE x8 speed
• If you intend to install three expansion cards into PCIE x16 slots, these two
PCIE x16 lanes will auto arrange from x16/ x0 to x8/ x8
• If you intend to install only one expansion card, make sure thatthe
expansion card is installed on the mazarine PCIE x16 slot(PCI_EX1)
To install an expansion card:
1 Perform the preinstallation instructions described on page 48.
2 If necessary, remove any cables that prevent access to the processor
sockets.
3 Locate an empty expansion slot that is compatible with the specification of
the card you intend to install.
4 Press the release latch of the slot cover opposite the selected expansion
slot.
5 Pull out the slot cover and store it for reassembly later.