Preparation before assemble:
1.Clean the room for work
2.Identify the area for material
3.Prepare the implement, equipment, materials as bellow：
1) working table
2) Screw-driver: Philips-head screwdriver, Hex-head screwdriver
3) Knife
4) Glove
5) Cleaning cloth
6) ESD protection
After unplugging the power cord, the power board still have power energe. Please pay attention when
disassembling/assembling.
S1
Assemble I/F BD and P/BD
from SHD.
Before Disassembling & Assembling, monitor need to be put on the sponge and
the Insulation glove must be wore during the process.
Put the SHD on the worktable. Locate the P/BD into the SHD.
Insert FFC LVDS to the I/F BD. Insert the wire on the P/BD to the I/F BD.
Locate the I/F BD into the SHD. Lock 6 screws to PCBA and stick 1 mylar to fasten the
wire on the SHD as picture 2.
Assemble the Mylar on the SHD as the picture 3.
PICTURE 1 PICTURE 2 PICTURE 3
Take the Panel and insert lamp wire to panel marked as picture 1.
Assemble the MF to the panel and lock 9 screws to the MF as picture 2.
Stick 1 piece of adhesive tape on the little connector of lamp wire as picture 3.
PICTURE 1 PICTURE 2 PICTURE 3
To Next Page
Loading...
