Do you have a question about the ACM 200 Series and is the answer not in the manual?
Output | 4-20 mA, HART |
---|---|
Accuracy | ±0.1% of span |
Operating Temperature | -40 to 85°C |
Input | 4-20 mA |
Frequency Range | Not applicable |
Output Power | Not applicable |
Modulation | Not applicable |
Details AMC's liability limitations and warranty exclusions.
States AMC's right to change specifications without obligation.
Outlines procedures for returning products for warranty service.
Provides fields for specific transmitter details like order number, part, and serial numbers.
Lists factory default settings for gas type, range, and calibration points.
Describes the AMC-200 series unit's purpose and output signal.
Details sensor type, response time, drift, output, operating conditions, and life.
Provides guidance on selecting a suitable mounting location and method.
Explains cable requirements, selection chart, and wiring considerations for signal transmission.
Details how to connect the transmitter output terminals to monitor input terminals.
Explains connecting transmitters to external devices like computers or dataloggers.
Describes the expected behavior and signal output of the transmitter after stabilization.
Explains the remote calibration feature, adjustments, and calibration frequency.
Lists the necessary tools and equipment for performing calibration.
Provides a step-by-step guide for setting up and performing transmitter calibration.
Details how to perform Zero and Span adjustments for calibration.
Describes general cleaning and care instructions for the unit.
Lists conditions for sensor replacement and identifies the part number.