ACM 200 Series - Table of Contents

AMC-200 Transmitter
i
TABLE OF CONTENTS
Section Title Page
1 WARRANTY............................................................................................................ iii
1.1 LIABILITY...........................................................................................................iii
1.2 MODIFICATIONS AND SUBSTITUTIONS.........................................................iii
1.3 PRODUCT RETURN .........................................................................................iii
2 PRODUCT INFORMATION..................................................................................... iv
2.1 TRANSMITTER..................................................................................................iv
2.2 FACTORY SETTINGS .......................................................................................iv
3 PRODUCT DESCRIPTION ...................................................................................... 1
3.1 GENERAL DESCRIPTION................................................................................. 1
3.1.1 SENSOR SPECIFICATIONS ................................................................................ 1
4 INSTALLATION ....................................................................................................... 2
4.1 LOCATION AND MOUNTING............................................................................ 2
4.2 CABLE SELECTION AND WIRING ................................................................... 3
4.3 TRANSMITTER TO MONITOR WIRING ........................................................... 5
4.3.1 INTERFACING TO COMPUTER, DATALOGGER, OR NON-AMC MONITOR ..... 5
5 OPERATION AND CALIBRATION .......................................................................... 7
5.1 OPERATION...................................................................................................... 7
5.2 CALIBRATION ................................................................................................... 7
5.2.1 EQUIPMENT REQUIRED..................................................................................... 7
5.2.2 TRANSMITTER CALIBRATION/VERIFICATION SET-UP PROCEDURE............. 8
5.2.3 ADJUSTMENTS ................................................................................................... 9
6 PREVENTIVE MAINTENANCE.............................................................................. 10
6.1 GENERAL........................................................................................................ 10
6.2 SENSOR REPLACEMENT .............................................................................. 10