Acrel AMC Series - Page 28

25
0265H
DO1 low alarm enable
R/W
Enable at 0 (same as DO setting menu 5.4.3 in
In.=0)
Uint16
0266H-026BH
DO2 alarm settings
R/W
Same as DO1 alarm setting, high and low
voltage value and voltage value in DO2
combination alarm
Uint16
026CH-0271H
DO3 alarm settings
R/W
Same as DO1 alarm setting
Uint16
0272H-0277H
DO4 alarm settings
R/W
Same as DO1 alarm setting
Uint16
0278H
DLT645 address setting
R/W
High four-bit address, hex form
Uint16
0279H
DLT645 address setting
R/W
Medium four-bit address, hex form
Uint16
027AH
DLT645 address setting
R/W
Low four-bit address, hex form
Uint16
027BH
DO2 combination alarm
over frequency value
R/W
0000-9999 (same as DO2 setting menu 5.4.3
H-F)
Uint16
027CH
DO2 combination alarm
underfrequency value
R/W
0000-9999 (same as DO2 setting menu 5.5.3
L-F)
Uint16
027DH
DO2 combination alarm
over power value
R/W
-9999 ～ 9999 (the same as the DO2 setting
menu 5.4.3 H-P)
Int16
027EH
DO2 combination alarm
underpower value
R/W
-9999 ～ 9999 (L-P in the same DO2 setting
menu 5.4.3)
Int16
027FH
DO2 combination alarm
over current value
R/W
0000-9999 (the same as the DO2 setting menu
5.4.3 H-I)
Uint16
0280H
DO2 combination alarm
underpower factor value
R/W
-1000 to 1000 (L-PF in the same setting as the
DO2 setting menu 5.4.3)
Int16
0281H
DO2 combination alarm
overvoltage imbalance
value
R/W
-1 to 999 (H-b.U in the same setting as the
DO2 setting menu 5.4.3)
Int16
0282H
DO2 combination alarm
overcurrent imbalance
value
R/W
-1 to 999 (H-b.I in the same setting as the
DO2 setting menu 5.4.3)
Int16
03E8H
Alarm status of DO2
combined alarm
R
bit0=“H- U”（high voltage）
bit1=“L- U”（low voltage）
bit2=“H- F”（high frequency）
bit3=“L- F”（low frequency）
bit4=“H- P”（high power）
bit5=“L- P”（low power）
bit6=“H- I”（high current）
bit7=“L- PF”（low power factor）
bit8=“H- b.U”（over voltage unbalance, set as
-1 phase miss）
bit9=“H- b.I”（Current imbalance）
Uint16