ACT 10 - Changing Codes; Setting Timers

4
0 Toggled
1 Timed
2 Timed
3 Timed Timed
4 Timed
5 Timed Timed
6 Timed Timed
7 Timed Timed Timed
Output Function Code Door Output Door 2/Output 2 Output 3
Default function code is 1 (Relay Timed) for all users. When the door is toggled open, this will
be indicated by the green indicator flashing.
ACT 10 Digital Keypad Operating & Installation Instructions
Changing Codes: Enter Programming Mode, then Press
Setting Switched Output Combinations: Enter Programming Mode, then Press
Step Keypad Entry Operation Example: Assign Toggle to User 7
1 1 Set Outputs
✘
9999 Enter programming
2
0-9 User number 0-9, 1 Set Outputs
3 0-7 Output function code 7 User 7
0 Door Toggle
✘
Exit programming
Step Keypad Entry Operation
12
Set Timers
2 0 - 4 (Timer number) Buzzer sounds indicating timing. wait required period.
3  (Stop timing) Buzzer stops – timer set.
Setting Timers: Enter Programming Mode, then Press
0 Relay time 5s
1 Door 2 / Output 2 time 5s
2 Output 3 time 5s
3 Door Ajar time 30s
4 Guest Buzzer time 2s
Timer Number Function Default
Timers may be set to any duration between 2 seconds and 4 minutes.
Default UserCodes:
Programming Code: 9999(99); User 1 Code: 1234(56). All others are inactive.
Step Keypad Entry Operation Example: Assign code 7529 to user 7
1 0 Change Codes
✘
9999 Enter programming
2
0-9,  User Number 0-9,  = programming code 0 Change Codes
3 0000(00)-9999(99) 4 digit code – 0000 deletes User code 7 User 7
7529 PIN code
✘
Exit programming