ACTSmart Operating and Installation Manual Rev 1.1
- 4 -
30 Second Programming Guide
30 Second Programming Guide30 Second Programming Guide
30 Second Programming Guide
(For typical Standalone System)
1. Enter Programming Mode.
Press ✘ button followed by the programming code (default is 9999)
The LED will flash amber.
2. Add a Batch of Cards
Press 10, then present the first card in the batch followed by the last card in the batch.
Press ✔ button to complete.
3. Set Desired Door Relay Active Time
Press 20, and then enter the desired number of seconds from 000-255 (three digits with
leading zeros). Press ✔ button to complete.
4. Change Programming code
Press 23, then enter new 4-digit programming code.
5. Exit Programming Mode
Press the ✘ button. The LED turns red.
The ACTSmart is now ready for normal use.
Note: The ACTSmart may be returned to its factory default condition at any time by entering the
programming mode and pressing 80 followed by the ✔ button.
For information on programming the advanced features and networking the ACTSmart range,
please refer to the complete programming guide.
Unit 8, Tallaght Business Centre,
Whitestown, Dublin 24, Ireland.
Tel: 353-1-4622585 Fax: 353-1-4622587
Web: http://www.accesscontrol.ie E-mail: sales@ accesscontrol.ie
Copyright
2003 Access Control Technology Ltd.
To Next Page
Loading...
Need help?
General
