Sopix
²
• User manual
ENGLISH
17
USE
7.1. ACQUISITION OF AN X-RAY IMAGE
First, switch on the PC on which the Sopix² system is installed and launch the imaging software (Sopro Imaging).
• Set your generator and the timer.
• Slip the sensor into a hygienic protector.
NOTE:
• Place the sensor in the patient’s mouth parallel to the long axis of the tooth with the active face against the tooth.
NOTE:
• Move the generator closer to the patient’s head. Make sure the generator cone is parallel to the sensor
positioning.
• Activate the timer trigger.
Once the exposure is finished, the imaging software downloads the x-ray image onto the screen.
If using a positioning kit, refer to the instructions provided with this kit.
For further information, please refer to chapter 7.2 « Using sensor protectors ».
7
To Next Page
Loading...
