ACT550 USER MANUAL
480258EN-1.0 29/06/2016 Page 26 of 34
POL.
C/ CALIDAD, 66
28906 GETAFE
Tel: +34 91 665 26 26
Fax: +34 91 665 23 24
N.I.F. ES-A-28905065
ER-
12. Troubleshooting
SYMPTOM SOLUTION
Sound cannot be heard in a
particular zone.
Make sure that the source is selected to play in the area.
Make sure that the Mute function is not activated.
Adjust the volume to an appropriate level.
If the source is USB, SD Card or Audio Wireless, verify that the
reproduction is in PLAY status.
The functions of the radio AF and
TA are not activated.
Make sure that RDS is activated in the radio settings.
The AF function does not work
correctly, do not make jumps to
alternative frequencies.
Make sure that the AF function is active. The AF icon must be on
the LCD screen.
Make sure the AF REGIONAL parameter settings radio.
The guide microphone is not heard
in the driver area.
Make sure that the microphone is set to mode .
When you select a video from a
USB device or SD Card, this does
not play and skip to the next video.
Make sure the video player supports the video format.
When you turn on the equipment
with a USB or SD Card device
connected, the connected device is
not recognized.
Some USB or SD Card devices do not allow detection at start-up.
Remove the device and reinsert.
The equipment does not respond
to the remote control.
Check remote control battery. Replace if necessary.
The equipment does not respond
to any button.
Reset the equipment according to Section 3.2. Reset of the
Equipment.
If the problem keeps on, reset and restore the configuration
according to Section 3.3. Reset and Restore the Factory
Settings.
If the problem is not solved, contact the technical service.
To Next Page
Loading...