64
Actiontec USB/Ethernet DSL Gateway User Manual
Restore Default Settings
To restore the Gateway to its factory default settings, select Restore Default Settings
from the “Utilities” screen. When the “Restore Default Settings” screen appears, click
Restore Default Settings. Any changes made to the Gateway’s settings will be lost
and the factory default settings restored. During this process, the Gateway’s Power
light flashes and the Gateway is disabled.
N
Warning: Do not unplug the Power cord from the Gateway
during the Restore Default Settings process. Doing so may result
in permanent damage to the Gateway.
When the Power Light stops flashing and glows steadily green, the Gateway is fully
operational.
Upgrade Firmware
Selecting Upgrade Firmware in the “Utilities” screen generates the “Select
Upgrade File” screen. Actiontec periodically posts firmware upgrades to enhance
the Gateway’s capabilities. Follow the instructions on-screen to upgrade the
Gateway’s firmware.
To Next Page
Loading...
Need help?
General
