Installing the Receiver
is chapter explains how to connect the ScreenBeam Pro Wireless
Display Receiver to an HDTV monitor. Make sure you have all the
contents from the Receiver’s package available before starting.
Connecting the Receiver to an HDTV
To connect the Receiver to an HDTV monitor:
1. Get the Receiver, power cord, and HDMI cable from the
ScreenBeam Pro package.
2. Plug one end of the supplied HDMI cable into the HDMI port on
the Receiver, and the other end into an available HDMI port on the
HDTV.
3. Plug one end of the power cord into the Receiver, and the other end
into a power outlet. When Steps 1, 2, and 3 are complete, the
hardware should be connected as shown in the gure, below.
Note: e power outlet and cable may appear dierent than those shown
in the gure.
5
To Next Page
Loading...
