9
b) Software Overview
Once you have completed the installations, open the software and you will then see the main dashboard and the
menu on the left-hand side. Connect one or more devices via the cradle.
No GENEActiv devices connected
i. GENEActiv devices
Once the device is connected, you will see the device number(s) displayed in the panel underneath GENEActiv
devices section.
Under the device(s) serial numbers you will see the the length of data recorded and frequency, together with the
battery charge level. Hover over the battery icon, it will give you the percentage of battery charge.
Once you select/click a device, at the bottom of the page, on the right-hand side you will notice three tabs.
• INFORMATION: this is where the device’s capabilities will be displayed. This tab displays information
about the device(s) connected and existing stored data.
• CONFIGURE: this tab allows the GENEActiv device(s) to be configured and details of the trial and test
subject to be entered on the device.
• EXTRACT: This is where you will go to extract the data once recording has finished