To Next PageTo Next Page
Need help?Do you have a question about the Actron Sunpro CP7673 and is the answer not in the manual?
General| Type | Digital Multimeter |
|---|---|
| Display | LCD |
| Diode Test | Yes |
| Continuity Test | Yes |
| Continuity Buzzer | Yes |
| Battery Type | 9V |
| Safety Rating | CAT II 600V |
| Display Digits | 3.5 digits |
| DC Voltage Range | 200mV, 2V, 20V, 200V |
| AC Voltage Range | 200V |
| DC Current Range | 200μA, 20mA, 200mA, 10A |
| Resistance Range | 200Ω, 2kΩ, 20kΩ, 200kΩ, 2MΩ |
| Battery Test | 1.5V/9V |
Lists essential safety gear: fire extinguishers, goggles, and fireproof containers.
Advises on avoiding hazards from clothing, jewelry, hot surfaces, high voltage, and smoking.
Covers ventilation, parking brake, battery handling, jack usage, and hot surfaces.
Checks the condition of distributor points for proper operation.
Measures the dwell angle of the distributor points for ignition timing.
Assesses mechanical wear in the distributor by observing dwell changes.
Measures and adjusts engine idle speed using RPM readings.
Adjusts idle mixture screws to achieve the smoothest idle and highest RPM.
Evaluates the Positive Crankcase Ventilation (PCV) valve operation.
Checks the air filter's condition by observing RPM changes with/without it.
Assesses spark plug wire and ignition component health via indicator lamp.
Tests the battery and starter system voltage during cranking.
Evaluates the alternator/generator output and charging system performance.
Tests the vehicle's battery cables for voltage drop and proper connections.
Evaluates the starter solenoid's performance by measuring voltage drop.
Checks the starter switch circuit for voltage drop and connection integrity.
Assesses the starter cable's condition and connections for voltage drop.
Tests the ground cable and connections for voltage drop.
Measures the output current of the alternator or generator.
Evaluates the alternator/generator circuit for voltage drop and connections.
Checks the ground connection of the alternator/generator for voltage drop.
Tests the ground connection of external regulators for voltage drop.
Tests the ignition resistor circuit for proper voltage readings.
Measures the resistance of spark plug wires.
Checks the condition of the ignition condenser by measuring its resistance.
Tests fuses and light bulbs for continuity by measuring resistance.
Evaluates the electronic ignition system circuit for voltage and component integrity.
Measures the resistance of the distributor pickup coil.
Measures the primary winding resistance of the ignition coil.
Measures the secondary winding resistance of the ignition coil.
Tests the ballast resistor for proper resistance values.
Checks the ground connection of the electronic ignition module.
