Actron Sunpro CP7673 - Ignition Plug Cable Test; Condenser Test

11. IGNITION PLUG CABLE TEST
OHM gi
EA HIGH] amp s R
é VOLTS &
Ez tow) WELL 4%,
NO CONNECTION NECESSARY
A. Turn the test selector to the OHMS position and put the range switch in the
HIGH position. Refer to the OHMS CALIBRATION page at the beginning of
this manual and calibrate the HIGH OHMS scale.
B. Turn the ignition switch to the OFF position and remove the distributor cap.
C. One at a time, remove each spark plug wire from the spark plug and connect
either test clip to the end of the spark plug wire and the other test clip to the cor-
responding metal segment inside the distributor cap.
D. Observe the HIGH OHMS scale.
RESULTS: OHMS READING IS MORE THAN 30,000 — Defective spark plug cable
or corroded socket in the distributor cap.
OHMS READING IS LESS THAN 30,000 — Spark plug cable is OK.
12. CONDENSER TEST
OHM gg
CA HIGH] AMP S
f o VOLTS A K
€ 2 Low | DWELL KN
RPM
A. Turn the test selector to the OHMS position and put the range switch in the `
HIGH position. Refer to the OHMS CALIBRATION page at the beginning of
this manual and calibrate the HIGH OHMS scale.
B. Disconnect condenser wire from the circuit to be tested.
C. Connect either test clip to the condenser wire and the other test clip to the
condenser body.
D. Observe the HIGH OHMS scale.
RESULTS: OHMS READING IS BETWEEN 0 OHMS AND INFINITY (2) —
Condenser is defective.
OHMS READING IS INFINITY (ee) — Condenser is OK.
NO CONNECTION NECESSARY
18