Actron Sunpro CP7673 - Fuse;Light Bulb Test

13. FUSE/LIGHT BULB TEST
OHM
‘A
HIGH AMP S
VOLTS `
Low | DWELL %,
C7
RPM
A. Turn the test selector to the OHMS position and put the range switch in the
HIGH position. Refer to the OHMS CALIBRATION page in the front of this
manual and calibrate the HIGH OHMS scale.
B. Remove fuse or bulb from circuit to be tested.
C. Connect test clips to the fuse ends or to terminals on bulb to be tested.
D. Observe the LOW OHMS scale.
RESULTS: OHMS READING IS INFINITY (ce) — Fuse or bulb is burned out.
OHMS READING IS NEAR 0 OHMS — Fuse or bulb is OK.
19