To Next PageTo Next Page
Need help?Do you have a question about the ActronAir Classic 2 CCA170S and is the answer not in the manual?
General| Cooling Capacity | 5.0 kW |
|---|---|
| Heating Capacity | 5.5 kW |
| Indoor Unit Type | Wall-mounted |
| Power Supply | 220-240V, 50Hz |
| Outdoor Unit Noise Level | 52 dB |
| Outdoor Unit Dimensions (HxWxD) | 550 x 780 mm |
Inspect unit, components, and accessories upon receipt for damage. Verify nameplate details.
Installer must ensure compliance with relevant council, state, and federal codes.
Overview of ActronAir Ducted units, design, efficiency, and components.
Essential safety guidelines for installation, servicing, and operation of the unit.
Procedures for safe and compliant handling, recovery, and recycling of refrigerants.
Access operation manuals by downloading them from the ActronAir website.
Use NFC-enabled mobile device to read tag and access operation manual.
Visual identification and description of the outdoor unit's main parts.
Details of the control panel for single-phase units (10-17kW).
Details of the control panel for three-phase units (13-23 kW).
Control panel specifics for three-phase units with soft starter option.
Physical dimensions, weight, and minimum clearances for CRA100S model.
Physical dimensions, weight, and clearances for CRA130S/T and CCA130S models.
Physical dimensions, weight, and clearances for CRA150S/T and CCA150S models.
Safe methods and equipment required for lifting the outdoor unit.
Steps for preparing the outdoor unit before installation, including panel removal.
Procedures and standards for field pipe connection and brazing.
Method for pressurizing the system to check for leaks.
Steps for evacuating the system to remove moisture and non-condensables.
Specifications for the power supply needed for the unit, including voltage and frequency.
Importance of balanced voltage for three-phase compressor operation.
Diagram illustrating the main electrical connections for the split unit.
Recommended maximum lengths for various cable runs within the system.
Standard wiring setup for controllers and sensors.
Alternative wiring setup for controllers and sensors.
Guidelines for cable lengths when implementing zoning control.
Specific wiring instructions for the LR7 wall controller.
Wiring details for optional LM-RS-2 and AERSS sensors.
Configuration and operation of demand response control features.
How to configure the unit's control source (e.g., 3rd Party, Wall Controller, BMS).
Third party control input for single speed indoor fan operation.
Third party control input for variable speed indoor fan operation.
Wiring and configuration for output signals indicating unit status.
How to control the unit's on/off state remotely.
Indoor fan performance data and settings for specific models.
Indoor fan performance data and settings for specific models.
Indoor fan performance data and settings for specific models.
Factory charge amounts and additional refrigerant per meter for various models.
Procedure for charging refrigerant based on sub-cooling and superheat.
Steps and parameters for achieving optimal cooling/heating performance.
Method to check and adjust sub-cooling for correct refrigerant charge.
Method to check and adjust superheat for optimal evaporator performance.
General guidelines for regular servicing of the unit.
Instructions for cleaning the outdoor unit's condenser coils.
A checklist detailing recommended service intervals and tasks.
Troubleshooting steps for when the system fails to start.
Diagnosing and resolving issues related to insufficient indoor airflow.
Troubleshooting steps for reduced cooling or heating performance.
Resolving problems with setting or adjusting temperatures.
Causes and solutions for the outdoor coil freezing over.
Identifying and rectifying causes of unpleasant odors from the indoor unit.
List and explanation of error and status codes displayed by the unit.
Identification and part numbers for major components of the outdoor unit.
Information required for the start-up and commissioning report.
