To Next PageTo Next Page
Need help?Do you have a question about the ActronAir Classic 2 CRA150T and is the answer not in the manual?
General| Brand | ActronAir |
|---|---|
| Model | Classic 2 CRA150T |
| Category | Air Conditioner |
| Language | English |
Verify air conditioning unit and accessories against invoice for damage. Check nameplate details.
Guidelines for installation and service by licensed technicians, WH&S, and electrical safety.
Procedures for recovering, recycling, and handling refrigerants safely and legally.
Consult SDS for proper handling, health, safety, storage, and disposal requirements.
Steps for preparing the outdoor unit for installation, including removing panels and earth cable.
Guidelines for R-410A refrigerant piping, brazing with nitrogen, and equivalent pipe length calculations.
Steps for pressurizing the system to 2500kPa in stages for testing.
Detailed steps for performing a triple evacuation to remove moisture and non-condensables.
General requirements for electrical work, wiring diagrams, and power supply.
Procedure for providing power supply, compatibility checks, and protection devices.
Diagram and notes for connecting mains and control wiring for the split unit.
Configuration options for control source (3rd Party, Wall Controller, BMS, etc.) on the Outdoor Board.
Wiring and configuration for third-party control of single-speed indoor fan operation.
Wiring and configuration for third-party control of variable-speed indoor fan operation.
Overview of refrigerant charging methods using sub-cooling and superheat parameters.
Steps to adjust refrigerant charge for optimal performance in cooling and heating modes.
Procedure to check system sub-cooling against specified ranges and adjust refrigerant charge.
Guide to diagnose and resolve common faults like no airflow, insufficient cooling/heating, and steam emission.
