To Next PageTo Next Page
Need help?Do you have a question about the ActronAir Classic 2 CRA200T and is the answer not in the manual?
General| Brand | ActronAir |
|---|---|
| Model | Classic 2 CRA200T |
| Category | Air Conditioner |
| Language | English |
Inspect unit, components, and accessories for damage upon receipt. Check nameplate.
Installer ensures compliance with relevant codes, regulations, and building standards.
Procedures for recovering, recycling, and reusing refrigerants according to Australian law.
Consult SDS for handling, health, safety, storage, and disposal of refrigerants.
Use appropriate equipment for refrigerant recovery to minimize emissions and achieve low vacuum.
Operation manuals can be downloaded from the ActronAir website.
Using NFC to view and download operation manuals via mobile apps (iOS).
Using NFC to view and download operation manuals via mobile apps (Android).
Illustration and labels for the control panel of single-phase units.
Illustration and labels for the control panel of three-phase units.
Illustration and labels for the control panel of three-phase units with soft starter.
Dimensions, weight, corner weights, and clearances for CRA100S model.
Dimensions, weight, corner weights, and clearances for CRA130S/T and CCA130S models.
Dimensions, weight, corner weights, and clearances for CRA150S/T and CCA150S models.
Dimensions, weight, corner weights, and clearances for CRA170S/T and CCA170S/T models.
Dimensions, weight, corner weights, and clearances for CRA200T and CCA200T models.
Dimensions, weight, corner weights, and clearances for CRA230T and CCA230T models.
Guidelines and precautions for piping and brazing with R-410A refrigerant.
Procedure for pressurizing the system for testing.
Steps for performing a triple evacuation on the system.
Checking voltage balance for three-phase compressors to prevent overheating.
Diagram showing mains and control wiring connections between indoor and outdoor units.
Recommended wiring diagram and maximum cable lengths for controllers and sensors.
Alternative wiring diagram and maximum cable lengths for controllers and sensors.
Wiring details for LR7 wall controller to the indoor unit.
Wiring details for optional LM-RS-2 remote sensors.
Wiring details for optional AERSS duct sensors.
Wiring and configuration for single-speed fan control via third-party input.
Wiring and configuration for variable-speed fan control via third-party input.
Wiring and configuration for run and fault indication outputs.
Procedures for turning the system On and Off remotely using a switch or relay.
Performance data for EVA100S/EFA100S fans, showing airflow, static pressure, and power.
Performance data for EVA130S/EFA130S fans, showing airflow, static pressure, and power.
Performance data for EVA150S/EFA150S fans, showing airflow, static pressure, and power.
Performance data for EVA170S/EFA170S fans, showing airflow, static pressure, and power.
Performance data for EVA200S/EFA200S fans, showing airflow, static pressure, and power.
Performance data for EVA230S/EFA230S fans, showing airflow, static pressure, and power.
Parameters and method for sub-cooling and superheat charging.
Procedure for checking and adjusting sub-cooling for optimal performance.
Procedure for checking and adjusting superheat for optimal evaporator capacity.
General procedures for regular servicing and maintenance of the unit.
Instructions for cleaning condenser coils to maintain optimal performance.
