33
User’s Manual T1-16 Tactical Ascender
TROUBLE SHOOTNG GUIDE
If this guide does not solve your problems,
contact ActSafe Systems AB or an ActSafe
approved distributor.
TROUBLE SHOOTING GUIDE
No power when main switch is pressed
No response to speed handle
The ascender stops on ascent/descent
PROBABLE CAUSE REMEDY
Lights are switched o, not showing if
the ascender is switched on/o.
Push the power button and operate the handle. Switch lights back
on when ascender is operating.
The battery is at. Recharge the battery.
PROBABLE CAUSE REMEDY
The ascender is not switched on. Switch the power on.
The remote control is switched on.
Restart the ascender or wait for the remote to turn o after 10 se-
conds of inactivity.
The battery is at. Recharge the battery.
PROBABLE CAUSE REMEDY
The ascender is overloaded.
Ensure the load is not exceeding lifting capacity and restart
by return the handle to zero.
The rope is jammed. Clear the jam.
The battery is at. Recharge the battery.
To Next Page
Loading...
