ACU-RITE 02085 - Specifications; FCC Information

19
Specications
TEMPERATURE RANGE
Outdoor: -40ºC to 70ºC; -40ºF to 158ºF
Indoor: 0ºC to 50ºC; 32ºF to 122ºF
HUMIDITY RANGE
Outdoor: 1% to 99%
Indoor: 1% to 99%
WIND SPEED
0 to 159 kph; 0 to 99 mph
WIND DIRECTION
INDICATORS
16 points
RAINFALL MEASUREMENT
0.25 mm (0.01 inches) and up
WIRELESS RANGE
100m / 330ft depending on home construction materials
DISPLAY OPERATING
TEMPERATURE
-7ºC to 49ºC (20ºF to 120ºF)
OPERATING FREQUENCY
433 MHz
POWER
Display: 5V adapter
3 x AA alkaline batteries (optional)
Sensor: 4 x AA alkaline or lithium batteries
DATA REPORTING
Wind Speed: 18 second updates; Direction: 30 seconds
Outdoor temperature & humidity: 36 second updates
Indoor temperature & humidity: 60 second updates
FCC Information
Hereby, AcuRite, declares that this Weather Station is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:
1- This device may NOT cause harmful interference, and
2- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could
void the user authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation of the device.