12
Programmable Alarms
This display features programmable alarms that sound an alert to notify you when a
value (for outdoor temperature, humidity, wind speed or rainfall) has been reached
or exceeded. When an alarm is triggered, the display emits an audible beep and
ashes data in the affected category. You can customize the alarms by turning ON
or OFF the alarms you’d like activated or deactivated, and by inputting your own
values to trigger the alarm.
Setup an Alarm
1. Press and release the “ ” button until the reading for which you wish to set
an alarm is shown on the display. “ ” will be shown.
2. Press and release the “ “ or “ “ buttons until “ ” appears.
3. Press and release the “ “ button. The current alarm value will ash on the
display.
4. Press and release the “ “ or “ “ buttons to adjust the alarm’s value.
5. Press and release the “ ” button to save the alarm value.
6. Press and release the “ ” button to cycle to the next reading.
Disable an Alarm
1. Press and release the “ ” button until the reading for which you wish to
disable an alarm is shown on the display. “ ” will be shown.
2. Press and release the “ “ or “ “ buttons until “ ” appears.
3. Press and release the “ ” button to cycle to the next reading.
4. Repeat steps 1-3, as needed.
NOTE: To disable ALL alarms at once, press and HOLD the “ ” button for 10 seconds.
You will automatically exit alarm SET MODE if no buttons are pressed for 10
seconds. Enter alarm SET MODE at any time by pressing the “ ” button.
To Next Page
Loading...
